Few things brighten a GTA winter like a front yard full of holiday lights. Wrapping a maple, spruce or ornamental tree in lights makes a big impression from the street. But the way you hang those lights can affect the tree long after the holidays are over.
Lights wrapped too tightly, fastened with staples or left on for years can quietly damage bark, twigs and branches. Here’s how to go about putting Christmas lights on trees so your display looks great and your trees stay healthy.
Why Tight Wrapping Can Hurt Your Tree
Trees grow a little wider every year, and young trees and small branches grow fastest. A strand of lights wound tightly around a trunk or limb doesn’t stretch. As the wood expands, the wire starts to press into the bark.
Over time this can:
- Score or rub the bark, creating small wounds where insects and disease can get in
- Girdle twigs and branches, cutting off the flow of water and nutrients so the section above the wire dies back
- Weaken branches at the point where the wire has cut in, making them more likely to break under snow or wind
Damage like this often doesn’t show up until spring or summer, when a branch fails to leaf out. By then the cause is easy to miss.
Choose LED Lights
LED strings are the best choice for trees. They give off far less heat than old incandescent bulbs, which reduces the risk of drying out or scorching needles on evergreens. They’re also lighter, so they put less weight on thin branches, and they use much less electricity over a long holiday season.
Whatever you choose, make sure the lights and extension cords are rated for outdoor use and certified by a recognized body such as CSA or ULC.
Never Staple, Nail or Screw Into the Trunk
It’s tempting to fasten a strand in place with a staple gun or hang a light hook from a screw. Don’t. Every staple, nail and screw creates a wound that the tree has to seal off, and metal left in the wood can cause decay and become a hazard for anyone who cuts the tree later.
Use these instead:
- Soft plastic clips or light hooks that rest on branches
- Loose loops of string or stretchy plant ties
- Rope or light nets draped over shrubs and hedges
Wrap Loosely and Take Lights Down by Early Spring
A good rule is to leave enough slack that you can easily slide a finger or two under the strand. Spiral the lights loosely along the trunk and main limbs instead of winding them tight. Draping strands over the branches works even better on evergreens.
Plan to remove your lights by early spring, before new growth starts. Leaving them up year-round is how most girdling damage happens. Unwind the strands carefully instead of pulling, which can snap buds and small twigs.
Check for Weak or Dead Limbs First
Before you hang anything, take a careful look at the tree. Lights add weight, and so does wet snow and ice. A branch that’s already dead, cracked or poorly attached may not hold up to both.
Look for:
- Branches with no buds or with bark falling off
- Cracks or splits where limbs join the trunk
- Branches hanging over your driveway, walkway or roof
Have any problem limbs removed before you decorate. Our tree trimming and pruning team can clear deadwood safely, and a split trunk or weak union can often be supported with cabling and bracing. Learn more about what winter can do to trees in our post on common winter tree damages.
Ladder Safety and Power Lines
Most holiday injuries involving trees come from ladders, not lights. Keep these tips in mind:
- Set your ladder on firm, level ground. Frozen or icy surfaces can shift.
- Have someone hold the ladder and pass up strands.
- Don’t lean out to reach. Move the ladder instead.
- Never climb into the tree itself, especially when branches are cold, wet or icy.
- Stay well clear of overhead power lines. Ontario’s Electrical Safety Authority advises keeping yourself, your ladder and your decorations at least 3 metres away.
- Plug outdoor lights into a GFCI-protected outlet and don’t overload circuits.
For more electrical tips, see the Electrical Safety Authority’s holiday safety advice.
Watch for Salt and Snow Too
Holiday displays often sit beside driveways and walkways that get salted all winter. Salt spray and salty meltwater can damage roots and needles, and snow piled against trunks can hide decorations that rub bark. Our guide on how to protect your trees from salt, snow and ice covers simple ways to reduce this damage.
When to Call a Pro
If you want lights high in a large tree, it’s safer to leave the climbing to trained professionals. Consider calling an arborist when:
- The lights need to go higher than you can reach safely from a stepladder
- The tree is near power lines
- You’ve noticed deadwood, cracks or leaning before decorating
- The tree is a valuable mature specimen you don’t want to risk damaging
Get Your Trees Ready for the Holidays
A quick inspection and some careful pruning before you decorate can prevent broken branches and damage that shows up in spring. Five Star Tree Services helps homeowners across the GTA keep their trees safe and healthy all winter.
Call (416) 990-3355 or request a free quote. We’re based at 156 Duncan Rd, Richmond Hill.
